Filter
Top Products
the paper guide. This ridged marking corresponds to the extreme left
printing position and is called the edge mark.
The paper guide
Second, install the guide itself. Hold the paper guide vertically and
lower it so that the slots on either side fit onto the two pins as shown in
Figure 1-9 below. Then tilt the paper guide back until it rests at an
angle.
7
Loading Paper
Even if you normally use continuous-feed paper, it is simpler to test
the printer using a single sheet of paper. Be sure to use 14-inch-wide
paper so that none of the self test prints on the platen. See Chapter 3 for
instructions on loading continuous-feed paper, and information on
paper widths and multiple copies.
Figure 1-9.
Installing the paper guide
1-10
Setting Up the Printer