Filter
Top Products
Initialization
Whenever you turn the power on for the LQ, an
initialization
sequence is performed that sets the printer to its default values (see
Chapter 2 and Appendix E). Many word processors also send out an
initialization command to reset the printer before printing.
This initialization, or reset command, is sent to ensure that unknown
settings do not influence the information the program sends to the
printer. Usually this shouldn’t cause any problems. However, some
programs may send a command that also resets any SelecType settings
you’ve made (or settings made with a programming language).
For example, you may load a SelecType macro to print a document
in Letter Quality Courier, on 14-inch paper. However, when you begin
printing, the program reinitializes the printer, canceling the macro and
resetting the printer to the program’s default values.
Many word processors that send an initialization command also
provide a way to either change it or take it out altogether. Check the
program’s installation or setup section to find whether you can modify
the initialization command.
SelecType
You have the choice of using the four preset SelecType macros, or
creating your own. Two of the preset macros (1 and 2) for word
processing.
Macro 1 is for producing documents in draft form, primarily because
draft printing is quick. The macro prints in 10 pitch (pica) draft quality
The draft quality makes it fast, and 10 pitch makes it easy to read and
edit.
After editing a document in draft, you could select macro 2 to print
the document in Letter Quality Roman font. You can also create your
own macro, or change the current settings for that specific job.
Printer commands
The LQ-2500 is capable of many print styles, fonts, and
enhancements. However, your word processor must tell the LQ when to
use these various features by sending the proper printer commands.
Using the LQ-2500 with Application Programs
4-5