Filter
Top Products
Paper loading icons . . .
Both levers on the LQ-2500 have icons (small pictures) beside
them as shown in Figure 1-9. These icons (shown below) remind you
whether to push the
lever
back
or pull it forward when you load
paper.
Paper release lever back-When loading single sheets
of paper, or using the automatic sheet loading feature,
this lever should
be back.
Paper release lever forward-When using
continuous-feed paper, this lever should always be
forward.
Paper bail lever back-When preparing to use the
automatic sheet loading
feature, and when actually
printing, this lever should be back.
Paper bail lever forward-when loading
paper
with
the automatic sheet loading feature, pulling this lever
forward loads the sheet.
Now load a sheet of paper:
1. Remove the dust cover. Do not put paper in the printer before you
turn it on. The automatic single-sheet loading won’t work if paper is
loaded before turning the printer on.
2. Now turn the printer ON. The displays reads
[PAPER OUT], the
printer beeps, and the
PAPER OUT
light comes on.
3. Push the paper release and paper bail levers back. Note that the
paper bail lever must be in the printing (back) position now. You will
move it to the single-sheet loading (forward) position in step 5.
Setting Up the printer
1-11