Filter
Top Products
EPSON FX-2180 Service Manual Chapter 4 Disassembly and Assembly
4-8
4.2.4 Removing the HP Sensor
1.
Remove the printer cover, ribbon cartridge, front edge guide, and front
cover. (See section 4.2.1.)
2.
Disconnect the connector cable for the HP sensor.
IMPORTANT
Note the orientation of the HP sensor so you can
reinstall it the same way. See Figure 4-8.
3.
Remove the HP sensor from the front paper entrance by pushing up
and releasing the two clips at the bottom of the HP sensor.
2 clips securing the HP sensor
Figure 4-8. Removing the HP Sensor
4.2.5 Removing the PW Sensor Assembly
1.
Remove the printer cover and ribbon cartridge. (See section 4.2.1.)
2.
Remove the print head. (See section 4.2.3.)
3.
Remove the CB screw (2.5
×
5) securing the PW sensor to the ribbon
mask holder.
4.
Release the three clips on the CR cover that secure it to the bottom of
the CR assembly. Then lift the cover slightly.
5.
Remove the FFC from the PW sensor connector on the CR cover.
6.
Remove the PW sensor assembly along with the CR cover by pushing
and releasing the clip for the CR cover, as shown in Figure 4-9.
PW sensor assem bly
CB screw (2.5 x 5)
C R cover
CR assembly
PW sensor FFC
Figure 4-9. Removing the PW Sensor Assembly