Filter
Top Products
EPSON FX-2180 Service Manual Chapter 4 Disassembly and Assembly
4-16
4.2.11.2 Removing the PF Motor Assembly
1.
Remove the printer cover, front and rear edge guide assemblies, front
cover, paper eject assembly, and front and rear tractor units. (See
section 4.2.1.)
2.
Remove the panel board assembly. (See section 4.2.2.)
3.
Remove the upper housing assembly. (See section 4.2.7.)
4.
Remove the printer mechanism. (See section 4.2.11.)
5.
Move the paper release lever to the pull tractor position.
6.
Remove the CBS screw (3
×
6) and the CB screw (3
×
8) securing the
PF motor to the right sub frame.
7.
Remove the PF motor from the right sub frame.
IMPORTANT
Before attaching the PF motor to the right sub
frame, set the paper release lever to the pull
tractor position (full release position).
The CB screw (3
××
8) is used to secure the
upper part of the PF motor. The CBS screw
(3
××
6) is used to secure the lower part of the PF
motor.
The tightening torque for the CB and CBS
screws is 0.8 - 1.0 Nm (8 - 10 Kgf-cm).
CB screw (3 x 8)
C B S sc re w (3 x 6 )
P F m o to r
right sub fram e
paper release lever
Figure 4-22. Removing the PF Motor