Filter
Top Products
6.
When you are finished adjusting the image, press MEM SEL.
The LCD displays Mem Select :
nt,
where n is the
number of the current video mode. (If you do not want to
save your changes to the current video mode, press
MEM SEL again. The LCD displays the number of the current
video mode.)
7.
To save your setting(s), press
MEM STORE.
The LCD displays
the number of the current video mode. (If you modified a
factory-set video mode and you want to restore the factory
settings, see the next section.)
Note
You cannot store the same display information for two
different factory-set video modes.
Recalling a Factory-set Video Mode
When the monitor is using a factory-set video mode you
modified, you can recall the original settings for the mode.
When the LCD displays a factory-set video mode number
(1 through 14), follow the steps in this section to restore its
factory settings. (If the LCD is off, press the Brightness or
Contrast button to turn it back on.)
Note
You can recall the original settings only for factory-set video
modes. If you press MEM RCL when the LCD displays a
user-defined video mode number (15 through 22) or Mode
not found, you see the message Rcl unavailable!
For factory-set video modes, you can recall only the original
horizontal phase, width, vertical shift, and height settings.
You cannot recall vertical convergence, horizontal
convergence, or color temperature settings.
Professional Series II Monitor
27