Filter
Top Products
6. Type the default password config and press <Enter>. The connected unit downloads
the configuration menu (see figure 10).
NOTES: • The IP addresses and other variable shown in figure 10 are for illustration
only and may not match those on your unit.
• Many menu selections are not available if DHCP is selected. Select option
1 or 11 to toggle DHCP on and off.
• This procedure identifies the selections that you may need to make for
typical low level configuration only. See “Configuration Selections“
for details on all available selections.
Network Port 1 Network Port 2
============== ==============
0. Speed/Duplex: auto_10_100_1000 10. Speed/Duplex: fibre_fixed_1000F
1. Boot method: static [dhcp] 11. Boot method: static [dhcp]
2. address: 192.168.0.104 12. address: 192.168.1.2
3. netmask: 255.255.255.0 13. netmask: 255.255.255.0
4. gateway: 14. gateway:
5. broadcast: 15. broadcast:
6. mtu: 1500 16. mtu: 1500
7. controller ip: 192.168.0.101 17. ip forwarding: 0
8. controller port: 5432 18. webserver port: 80
9. Exit
Please select an option:
LAN Port 1 (RJ-45, , on figure 2) LAN port 2 (Optical, )
4 5
Figure 10. Configuration Menu
7. Change the settings as needed as follows:
NOTES: • Do not include leading zeros when typing IP addresses. For example, type
192.168.0.104; do not type 192.168.000.104.
• Settings that you need to change for a for typical low level configuration
operation are:
• Address (option 2 or 12) • Netmask (option 3 or 13)
• Gateway (option 4 or 14) • Controller IP (option 7)
• Once you have designated a codec as the controller using option 7, you
can access it via either of its LAN ports.
a. Type the option number and <Enter>.
b. Type the new setting and <Enter>.
c. Once all the changes have been made, type 9 and <Enter> to save all settings and
exit the menu.
8. Repeat steps 1 through 7 for each VNC 325 unit in the VN-Matrix system. Assign the
same controller IP address to each unit.
VN-Matrix 325 Serial Digital Over IP CODEC • Installation and Setup 18