Filter
Top Products
Decoder configuration
See figure 14.
a SDI Out BNC connector — Connect an SDI, HD-SDI, or 3G-SDI digital video device
to display the digital video that was streamed to the decoder (item
B
on figure 14).
The video output is in the same format as the originating source at the encoder. When
no video streams are being decoded, this output can provide either a frozen image of
the last received frame or a static splash screen. See “Decoder Video Configuration
Panel“ in the “Operation” section to configure the splash screen.
b SDI In BNC connector — If desired, connect a local SDI input of the same refresh rate
as the streamed video to act as a digital genlock signal for synchronizing the decoder to
a local standard.
NOTE: If you use the SDI In connector for a synch signal, you must configure the
decoder accordingly (see “Decoder Video Configuration Panel“ in the
“Operation” section).
Loop BNC connector — Not used.
12V DC
3A MAX
POWER
LAN12
OPTICAL
REMOTE
SDI
OUT
SDI
IN
RS-232
OVER LAN
Decoder Configuration
Decoded
Video
Monitor
Local SDI
(Optional)
Network
B
1 2
Figure 14. Video Connections in the Encoder Configuration
VN-Matrix 325 Serial Digital Over IP CODEC • Installation and Setup 24