Filter
Top Products
Decoder Streams Configuration Panel
1a
1d
1b 1c
Figure 37. Decoder Streams Configuration Panel
For each change made in the decoder streams configuration panel, click the
Update button in the video configuration panel to confirm the change.
Ä
Source stream selection — You can view the available active source (streams) by
opening the Source drop down box.
• Choose rtp(m) for multicast RTP streaming.
NOTE: rtp(m) is available only if you have enabled multicast streaming. See
“Enable multicast streaming“ in the “Installation and Setup” section.
• Choose rtp for unicast RTP streaming.
• Choose tcp for unicast TCP streaming.
NOTE: See “Data Transport Methods“ in the “Installation and Setup” section for
more information.
You can define the names by renaming the appropriate encoder device.
Å
Audio checkbox — Enable or disable the transport of the audio content associated
with the selected video stream (the audio stream) by selecting the Audio check box.
If enabled, the selected audio stream is listed adjacent to the audio heading in the
bandwidth list. If Audio is not enabled, the display is none.
û
Fec checkbox — Enable or disable the transport of the row (rowfec) and column
(colfec) content associated with the selected video stream by selecting the Fec check
box.
If enabled, the selected error correction streams are listed adjacent to the rowfec and
colfec headings in the bandwidth list. If Fec is not enabled, the display is none.
NOTES: • The encoder send error correction data only when it is enabled for
processing by a decoder.
• Error correction data is sent only for the audio stream.
ü
Bandwidth links — Click any of the Bandwidth links, video, audio, colfec (column
error correction), or rowfec (row error correction), to open the “Decoder Bit Rate and
Streams Page”, described on the next page.
VN-Matrix 325 Serial Digital Over IP CODEC • Operation 48