DXP DVI Pro and DXP HDMI Series • Matrix Software 9797
• Contents — Displays the Matrix Switcher + Help program, in which you can nd
procedures for using the software to control and configure the DXP.
• Switcher information — The two sections below the Contents option are not
menu options; they display information about your switcher:
• Model — DXP model name
• Config — Video and audio matrix size: V(nxn) A(nxn)
• Firmware Ver. — Firmware version to second decimal place
• LoggedOn as: — Administrator or User
• Connection – (For RS-232 or RS-422) “Com n” – baud rate,” or (for IP)
“IP – [IP address]”
• About this Program — Opens a window that displays information about the current
version of the Matrix Switcher Control Program.
Using Emulation Mode
Emulation mode lets you set up the software without connecting the DXP to the
computer.
NOTE: In emulation mode, you can emulate any matrix switcher that is supported by
the Matrix Switcher Control Program; you are not limited to the DXP.
1. Double-click the
MATRIX Switchers + Control Program icon in the Extron
Electronics group or folder.
2. On the Comm Port Selection window, select Emulate, then click OK.
3. On the Initialize Emulated Matrix Settings From window, select an emulation le (.mtx
extension), then click Open.
Figure 98. Selecting an Emulation File
NOTE: Selecting the Demo.mtx file provides a sample of a completed matrix
setup. Selecting the New.ini file or clicking Cancel provides a blank
setup screen to get you started.