Filter
Top Products
Using Diagnostic Functions
8-38 User’s Manual
• Turn off the printer.
• While pressing LOCK, FONT, and MENU, turn the printer on.
Continue pressing until the printer beeps.
3. Default values for MENU1 and MENU2 set at shipment
Table 8-3 lists the default values for MENU1 and MENU2 set at
shipment. Reset these values using the procedure described here.
This procedure does not reset the printer's hardware, printing
adjustment, and configuration options.
• Enter setup mode.
Place the printer offline and then press FONT and MENU
simultaneously. Wait for the printer to stop printing and check
that the <<FUNCTION>> menu is printed.
• Select DEFAULT.
Repeatedly press LOCK to position the yellow arrow beneath
DEFAULT. Press FONT or MENU to select DEFAULT. The
printer reprints the <<FUNCTION>> menu. The default values
in MENU1 and MENU2 are now reset.
• Either select new options for MENU1 or MENU2 or exit setup
mode, saving the default values set at shipment.
To exit setup mode and save new default settings, check that the
yellow arrow is positioned beneath SAVE&END. Then press
FONT or MENU.
For more information, see “Changing MENU1 and MENU2
Options” on page 8-11.
This section explains how to use the SELF-TST, HEX-DUMP, and V-
ALMNT diagnostic functions.
Use these functions to check printing quality and diagnose printer
problems. Note that HEX-DUMP is used mainly by programmers.
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT GAP-ADJ
Using
Diagnostic
Functions
(GAP-ADJ is printed only with APTC installed.)
DL6400/6600 Book Page 38 Friday, July 31, 1998 11:42 AM