Filter
Top Products
Using the Setup Menus
E-20 User’s Manual
Printing the self-test
The printing self-test is a convenient way to check print quality after
making adjustments using the GAP-ADJ or V-ALIGNMENT
function. You can start the printing self-test from setup mode.
To start the self-test, load paper in the printer. Then follow these steps:
1. Enter setup mode. If you just completed the pre-
vious exercise on the SAVE function, the printer is
in setup mode with the menu shown at the left.
2. Press F1 until SELF-TEST appears under Func.
3. Press F3 to select GO. The self-test starts with the
self-test execution message shown at the left.
4. Press F2 to stop self-test printing. Press F3 to re-
sume self-test printing.
5. Press F1 to exit self-test mode and return to the
SELF-TEST menu.
6. Press ONLINE to exit setup mode. The basic
menu reappears.
Func. ↓
SAVE
Item ↓ Option ↓
GO
Func. ↓ Item ↓ Option ↓
GO
SELF-TEST
EXIT STOP GO
Self-test printing
Func. ↓ Item ↓ Option ↓
GO
SELF-TEST
Form ↑
feed
Tear off
paper
Line ↑
feed
#E_AppendixE Page 20 Wednesday, September 2, 1998 10:05 AM