Filter
Top Products
Chapter 11 System Management
11.2 Functions in the Action Area for System
ETERNUS Web GUI User’s Guide
Copyright 2013 FUJITSU LIMITED P2X0-1090-10ENZ0
754
3 To allow access from a different subnetwork to the ETERNUS DX Disk storage system, click
the [Add] button.
→ The [Add Allow IP] screen appears.
4 Input "Connect IP Address" and "Length of Subnet Prefix", and click the [OK] button.
● Allow IP Setting
• Connect IP Address
Input the connect IP address that is to be displayed.
The following IPv6 addresses can be used; "global address", "unique local address", and "6to4
address". Refer to "Available IPv6 Address" (page 757)
for details.
The following input condition applies:
- xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation (Setup Network Environment)" (page 757)
for details.
Make sure to input "Connect IP Address" and "Length of Subnet Prefix" together.
• Length of Subnet Prefix
Input the prefix length of the connect IP address for the remote device (unit: bit).
Refer to "Available IPv6 Address" (page 757)
for details.