Filter
Top Products
10-6 SPARC Enterprise M8000/M9000 Servers Service Manual • June 2010
7. Ensure that the metallic underside of the wrist strap is in direct contact with
your skin. The wrist strap should be snug around the wrist so that it does not
rotate. See Section 1.4, “Antistatic Precautions” on page 1-6.
Caution – Before handling FRUs, be sure to connect the clip of the antistatic wrist
strap and of the antistatic mat to the server grounding port, and attach the band of
the wrist strap to one of your wrists. Place the FRUs on the grounded antistatic mat.
Failure to take these antistatic measures might result in serious damage.
8. Change the mode switch setting on the OPNL to the Locked position and pull
out the key.
The key cannot be pulled out at the Service position.
9. Remove the cable from the connector of the OPNL.
10. Using a Phillips screwdriver, loosen the two knob screws securing the OPNL,
and remove the OPNL from the front cover.
FIGURE 10-4 Removing the OPNL