Filter
Top Products
14-10 SPARC Enterprise M8000/M9000 Servers Service Manual • June 2010
5. Confirm that the target CD-RW/DVD-RW drive unit is unconfigured from the
domain.
From XSCF, execute cfgdevice -l to confirm that the relevant port is not displayed
in the current connection.
6. Connect the clip of the antistatic wrist strap and of the antistatic mat to the
server grounding port. See Section 1.4, “Antistatic Precautions” on page 1-6.
7. Ensure that the metallic underside of the wrist strap is in direct contact with
your skin. The wrist strap should be snug around the wrist so that it does not
rotate. See Section 1.4, “Antistatic Precautions” on page 1-6.
Caution – Before handling FRUs, be sure to connect the clip of the antistatic wrist
strap and of the antistatic mat to the server grounding port, and attach the band of
the wrist strap to one of your wrists. Place the FRUs on the grounded antistatic mat.
Failure to take these antistatic measures might result in serious damage.
8. Remove the CD-RW/DVD-RW drive unit to be replaced. (See
FIGURE 14-4 or
FIGURE 14-5)
a. Using a Phillips screwdriver, loosen the two knob screws securing the
CD-RW/DVD-RW drive unit.
b. While grasping the knob screws, pull out the CD-RW/DVD-RW drive unit
slowly from the slot.
9. Place the removed CD-RW/DVD-RW drive unit on an antistatic mat.
10. Mount the replacement CD-RW/DVD-RW drive unit by following the removal
instructions in Step 8 in reverse order.
Caution – Do not forcibly push the CD-RW/DVD-RW drive unit in when inserting
it. If the CD-RW/DVD-RW drive unit is forcibly inserted despite the presence of any
obstruction in a slot or any problems with the connector pin, serious damage may
result.
11. Attach the CD-RW/DVD-RW drive unit to the port.
Execute the cfgdevice -c attach -p <port no.> command of XSCF.
12. Confirm that the replacement CD-RW/DVD-RW drive unit is configured to the
domain.
From XSCF, execute the cfgdevice -l command to confirm that the specified port
number is displayed in the current connection.