Filter
Top Products
MAN607-S
28-03-2003 Page 4-26 of 53
4.9.28 Automatic sending status
[Name] Automatic sending status
[Format] ASCII ESC a
Hex 1B 61
Decimal 27 97
[Description] When this command is sent once, then the board
will transmit the status every time that it change
state.
4.9.29 Stop sending automatic status
[Name] Stop sending automatic status
[Format] ASCII ESC b
Hex 1B 62
Decimal 27 98
[Description] When this command is sent then it will turn off
transmitting status.
4.9.30 Color/Grey scale graphic
[Name] Colour / Grey scale graphic
[Format] ASCII ESC c n
Hex 1B 63 n
Decimal 27 99 n
[Description] When this command is sent then will the board
not feed. After the next graphic data (both
compression and not). The n is a percent of the
burn ratio, n can be from 0 to 15, and the burn
ratio is 100/15*n. This command is used by the
driver to make colour and grey scales printout.
4.9.31 Enable saving data
[Name] Enable saving data
[Format] ASCII ESC d
Hex 1B 64
Decimal 27 100
[Description] This command will enable that the boards save
values to the flash, this is made to ensure that a
wrong transmission not will change settings in
the board, remember to send the command
“Saving data to board”, to actual save the data.