Filter
Top Products
MAN607-S
28-03-2003 Page 4-32 of 53
Default:
PAGELENGHT=150mm
PAPEROFFSET=2mm
BLACKMARK=120 (120/8=15mm)
ESC+205+1+98+n
n: Bit 0: if set the board will transmit ’B’ everytime paper is
not detected at the paper detector.
Bit 1: if set the Black Mark function is enable.
Default n = 0.
4.9.43 Graphic data – non compressed
[Name] Graphic data – non-compressed
[Format] ASCII US d1,d2,..,dX
Hex 1F d1,d2,..,dX
Decimal 31 d1,d2,..,dX
[Range] n: [0;255]
X=54 for FTP627MCLxxx, X=72 for FTP637MCLxxx,
[Description] When the printer controller receives this command the X
graphic bytes (d1-dX) will be printed in one dot line. The
MSB in d1 is the left most dot and the LSB in dX is the right
most dot.
4.9.44 Graphic data – compressed
[Name] Graphic data – compressed
[Format] ASCII Y d1,d2,..,d(-Y)
Hex Y d1,d2,..,d(-Y)
Decimal Y d1,d2,..,d(-Y)
[Range] Y: [-X;-2]
n: [0;255]
X=54 for FTP627MCLxxx, X=72 for FTP637MCLxxx,
[Description] When the printer controller receives a byte that is –Y to –2
(Decimal 256-Y to 254) the following data is compressed
data. The number of compressed graphic bytes is the
negative value.
This means:
If Y = -10 (Decimal 246) the next 10 bytes is compressed
data.
The compressed data is as follows.
When a data byte is 0 (no dots activated) the next byte
received is the number of bytes that are 0. All other data is
send as non compressed.