Filter
Top Products
MAN607-S
28-03-2003 Page 4-28 of 53
[Description] N represents the time between that the board
registry incoming paper, and to it starts feed the
auto form feed length. The time is calculated as
n * 50msec. The default setting is 2 seconds.
The value is saved to flash. Legal values for n
are between 1 and 255.
4.9.37 Feed Paper
[Name] Feed Paper
[Format] ASCII GS n
Hex 1D n
Decimal 29 n
[Range] n: [-128;127]
[Description] When the printer controller receives this command the
paper will be fed n-dot lines. If the value is negative a
reverse form feed will be made.
4.9.38 Compensate Burn time
[Name] Compensate burn time
[Format] ASCII RS n
Hex 1E n
Decimal 30 n
[Range] n: [-15;15]
[Description] When the printer controller receives this command the burn
time will be compensated. If a negative value is send the
printout intensity will be lighter and if a positive value is
send the printout intensity will be darker.
4.9.39 Bar code width setting
[Name] Bar code width setting
[Format] ASCII ESC e m
Hex 1B 65 m
Decimal 27 101 m
[Range] 2<=m
[Default] m=6
[Description] Parameter n is ignored
Parameter m is used to determine the dot width of the
narrow and wide bar lines. The wide bar lines is equal to m
dots and the narrow is equal to m/2 dots (rounded down).