Filter
Top Products
MAN607-S
28-03-2003 Page 4-31 of 53
47 O O 47 99 Code C Code C 99
48 P P 48 100 Code B FNC 4 Code B
49 Q Q 49 101 FNC 4 Code A Code A
50 R R 50 102 FNC 1 FNC 1 FNC1
51 S S 51
4.9.42 Black Mark
[Name] Set black mark parameters:
[Format] ASCII RS n
Hex 1E n
Decimal 30 n
[Range] n: [-15;15]
[Description] When Black mark is enabled:
[Format] ASCII ESC+205+3+97+m+n+o
Hex 1B CD 03 61 m n o
Decimal 27 205 3 97 m n o
[Range] m = Page length 1…255
n = Paper offset 1…255
o = Black mark length 1…255
[Description] At printer stop on black mark the paper will be forwarded
the full length of the black mark. Paper out is detected if full
length of the Black Mark is feeded and sensor does not
detect paper.
At no paper in printer and printing is requested, form feed of
black Mark Length will be executed. At no paper detected
the printer will stop.
FF=0xC Feed paper forward until next Black Mark or rest of
page whatever comes first.
The following values can be set:
PAGE LENGTH (default 150mm) This value is the paper
length
PAPER OFFSET (default 2mm) This value is the length
between Black Mark and start of printing. Value must be
between 2 mm. and Page length – 2mm.
BLACKMARK LENGTH (default 15mm). This is the length
of the Black Marks.
The board can be set to transmit a ’B’ whenever the paper
is not detected at paper detect. This is typical when the
sensor encounters a Black Mark.
The following commands is used for enabling Black Mark