Filter
Top Products
RX200 S5 Options Guide 65
Completion Closing the server
12.2 Closing the server
Ê Position the housing cover so that it protrudes about 1 cm over the back
edge.
Make sure that each bolt is positioned in the corresponding nut.
Ê Push the housing cover all the way forward until it clicks into place.
Ê Fit the fan cover (see “Removing the fan cover” on page 20).
Ê Insert the server into the rack. (The operating manual for the server
describes how to install it).
V CAUTION!
At least two people are needed to position the server in the rack.
Ê Connect all power plugs to the power outlets and switch on the server.