Filter
Top Products
97
Error messages
www.gateway.com
Invalid partition table
■ The master boot record may be corrupt. For troubleshooting information,
see “The master boot record is corrupted” on page 106.
Invalid password
■ Enter your password again. Some passwords are case sensitive.
■ If you do not know the password, you may need to reinstall the software
you are trying to access.
■ Startup passwords are stored in BIOS. If this password has been set and
you do not know it, you may be able to reset the password through system
board jumper settings. For more information, see “Resetting BIOS
passwords” on page 91.
Keyboard not detected
■ See “The keyboard does not work” on page 108 for a possible solution.
■ Turn off the server, then check the keyboard cable.
Keyboard stuck key failure
■ Remove any objects that may be resting on the keyboard, then restart the
server.
■ Make sure that a key is not stuck. Clean the keyboard if necessary.
Memory errors were detected while the system started up
■ See “Memory errors were detected during server start up” on page 109 for
a possible solution.
Memory size error
■ Open the BIOS Setup utility, then save the memory configuration.
Missing operating system
■ The master boot record may be corrupt. For troubleshooting information,
see “The master boot record is corrupted” on page 106.
■ Use FDISK to make sure that your hard drive has an active partition. On
FDISK’s main menu, select the Set Active Partition option. In MS-DOS or
Windows 95, the only partition that can be set as active is the primary DOS
partition.