Gateway 960 Server User Manual


 
70
Chapter 4: Installing Components
www.gateway.com
Replacing the power supply
To replace the power supply:
1 Follow the instructions in “Preventing static electricity discharge” on
page 41.
2 Follow the instructions in “Opening the server case” on page 42.
3 Follow the instructions in “Installing a voltage regulator” on page 69 to
remove the upper voltage regulator module.
4 Disconnect the power supply cables from the system board, drives, and
the hot-swap bay’s SCSI backplane, noting their locations and orientation.
(You will reconnect the cables after you install the new power supply.)
5 Open the cable clips by lifting the clip release tabs.
Warning The power supply in this server contains no
user-serviceable parts. Only a qualified computer
technician should service the power supply.
Your server is supplied with a 3-wire AC power cord fitted
with the correct plug style for your region. If this plug does
not match the connector on your surge protector, UPS, or
wall outlet, do not attempt to modify the plug in any way.
Use a surge protector, UPS, or wall outlet that is
appropriate for the supplied AC power cord.