Filter
Top Products
48
Chapter 4: Installing Components
www.gateway.com
■ If cable-select is available (drive assignments will be marked on the
cable), the IDE cable assigns the master/slave positions to the drives
it connects. You can override these assignments using the jumpers on
the drives.
■ If cable-select is not available and only one drive is attached to an IDE
controller cable, configure the drive as master if it is a CD drive. If
two drives of any type are attached to the cable, configure one as
master and one as slave.
■ You may need to configure the drives you install using the BIOS Setup
utility. Press F2 at startup to open the BIOS Setup utility.
Installing a media drive
Use these instructions to install or replace a diskette, CD, or tape drive.
To install a 5.25-inch drive:
1 Follow the instructions in “Preventing static electricity discharge” on
page 41.
2 Follow the instructions in “Opening the server case” on page 42.
3 If you are replacing a drive, go to Step 7.
- OR -