Filter
Top Products
3.5-inch diskette or CD drives
27
5
Remove the metal shield from the front of the drive bay, if installed, by
placing a flat-bladed screwdriver in the metal shield tab and pulling it
outwards.
6 Snap the rails onto the drive, making sure the front rail extensions are
towards the front of the device.
7 Align the rails with the bay, and slide the drive into the chassis until the
locking tabs snap into place.
8 Connect the power and data cables to the back of the drive. (See drive
documentation for proper drive jumper settings and cable orientation.)
9 Reinstall the CD drive and 3.5-inch diskette drive (see “3.5-inch diskette
or CD drives” on page 24 for instructions.)
10 Close the case (see “Closing the case” on page 19.)
11 Reconnect the power and modem cords, then turn on the system.
12 Run the configuration software, if required.
Caution Your system was designed to adhere to electromagnetic
interference requirements and the shield is an integral part
of the system. Installing an approved device should
continue to maintain those standards. If you remove the
device you should reinstall the shield.