Filter
Top Products
CHAPTER2: Setting Up and Getting Started
18
Installing mouse batteries
Before using your mouse, you must install the two batteries
that came with it.
To install the mouse batteries:
1 Turn the mouse over and remove the battery cover (if
installed) by prying it up using a thin object (such as your
fingernail).
2 Insert two AA batteries according to the diagram inside
the battery compartment, then install the battery cover.
3 Your wireless mouse is synced with your computer at the
factory. However, if the mouse does not work after
installing new batteries, re-sync the mouse with the
computer by following the instructions in “Syncing the
keyboard and mouse” on page 22.
Warning
Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer. Dispose of used
batteries following the manufacturer’s instructions.
Pry up here
8512740.book Page 18 Thursday, September 27, 2007 2:43 PM