Filter
Top Products
5-4 ENWW
6 Press (down arrow button) or (up arrow button) to highlight
the desired link speed, and then press (select button).
7 To return to the
READY state, press (pause/resume button).
Disabling network protocols (optional)
By factory default, all supported network protocols are enabled.
Disabling unused protocols has the following benefits:
z It decreases printer-generated network traffic.
z It prevents unauthorized users from printing to the printer.
z It provides only pertinent information on the configuration page.
z It allows the LCD control panel to display protocol-specific error and
warning messages.
To disable network protocols
Note Do not disable the IPX/SPX protocol if Windows 98, Windows NT,
Windows Millennium Edition, Windows 2000, or Windows XP users
will be printing to the printer.
1 Press (select button) on the LCD control panel to enter
the menus.
2 Press (down arrow button) to highlight
CONFIGURE DEVICE,
and then press (select button).
3 Press (down arrow button) to highlight
I/O, and then press
(select button).
4 Press (down arrow button) to highlight
EIO X (where X = 1 or 2),
and then press (select button).
5 Press (down arrow button) to highlight the network protocol you
want to disable, and then press (select button).
6 Press (down arrow button) to highlight
ENABLE, and then press
(select button).
7 Press (down arrow button) to highlight
OFF, and then press
(select button).
8 Press
(pause/resume button) to return to the READY state.