Filter
Top Products
Adapter configurations 102
recommended selection is Auto and it is the default setting. To disable Flow Control, select Disable
from the Value list on the Advanced tab.
o Auto. (Default) Auto detect flow control
o Disable. PAUSE frame receipt and transmission is disabled
o Tx PAUSE. PAUSE frame transmission is enabled
o Rx PAUSE. PAUSE frame receipt is enabled
o Rx/Tx PAUSE. PAUSE frame receipt and transmission is enabled
• Speed & Duplex. The Speed & Duplex parameter allows the user to set the connection speed to the
network and mode. The Duplex Mode allows the adapter to transmit and receive network data
simultaneously. The adapter is set to Auto (optimum connection) by default. Set the speed and mode
as described below:
o 10 Mb Full. Sets the speed to 10 Mbps and mode to Full-Duplex
o 10 Mb Half. Sets the speed to 10 Mbps and mode to Half-Duplex
o 100 Mb Full. Sets the speed to 100 Mbps and mode to Full-Duplex
o 100 Mb Half. Sets the speed to 100 Mbps and mode to Half-Duplex
o Auto. (Default) Sets the speed and mode for optimum network connection (recommended)
NOTE: 1 Gbps speed is enabled by selecting Auto.
NOTE: Auto is the recommended selection. It allows the adapter to dynamically detect the line
speed and duplex mode of the network. Whenever the network capability changes, the
adapter will automatically detect and adjust to the new line speed and duplex mode.
The Half-Duplex selection forces the adapter to connect to the network in Half-Duplex mode.
The adapter may not function if the network is not configured to operate at the same mode.
The Full-Duplex selection forces the adapter to connect to the network in Full-Duplex mode. The
adapter may not function if the network is not configured to operate at the same mode.
• Wake Up Capabilities. The Wake Up Capabilities parameter allows the user to set the adapter to
wake up from a low power mode when it receives a network wake up frame. Two wake up frames
are possible: Magic Packet and Wake Up Frame. By default, the adapter is set to Both. To choose
the type of frame that will cause the adapter to wake up, select the appropriate option from the
Value drop-down list on the Advanced tab.
o Both. (Default) Selects both Magic Packet and Wake up Frame as wake up frames
o Magic Packet. Selects Magic Packet as the wake up frame
o None. Selects no wake up frames
o Wake Up Frame. Selects Wake up Frame as the wake up frame
NOTE: This property is not supported by NC150T adapters.
• WOL Speed. The WOL Speed parameter allows the user to select the speed at which the adapter
connects to the network while in Wake-on-LAN mode. By default, the adapter is set to Auto.
o 10 Mb. Sets the speed to 10 Mb
o 100 Mb. Sets the speed to 100 Mb