Filter
Top Products
Adapter configurations 97
o
Default = Auto
o Range = Auto, 10Mb, 100Mb
• Flow Control. Specifies the type of flow control that is needed.
o Default = Auto
o Range = Disable; Rx Pause; Tx Pause; Rx/Tx Pause; Auto
• Rx TCP Checksum Offload. Offloads the task of computing the checksum for incoming TCP or UDP
packets, thereby improving performance.
o Default = Enabled
o Range = Disabled; Enabled
• Tx TCP Checksum Offload. Offloads the task of computing the checksum for outgoing TCP or UDP
packets, thereby improving performance.
o Default = Enabled
o Range = Disabled; Enabled
• Tx IP Checksum Offload. Offloads the task of computing the checksum for outgoing IP packets,
thereby improving performance.
o Default = Enabled
o Range = Disabled; Enabled
• Rx IP Checksum Offload. Offloads the task of computing the checksum for incoming IP packets,
thereby improving performance.
o Default = Enabled
o Range = Disabled; Enabled
• Ethernet@WireSpeed (NC37xx, NC380x and NC77xx only). Enables linking at 100 Mbps when
using a cable that does not support Gigabit speed.
o Default = Enabled
o Range = Disabled; Enabled
NOTE: This property is not supported by NC7761 adapters.
• Large Send Offload. Normally, the TCP segmentation is performed by the protocol stack. By
enabling the Large Send Offload parameter, the TCP segmentation can be performed by the Gigabit
Ethernet Adapter. To enable the Large Send Offload parameter, select Enable from the Value list on
the Advanced tab.
o Default = Enabled
o Range = Disabled; Enabled
• IPMI. Enables Intelligent Platform Management Interface, which provides a means for monitoring,
control, and automatic recovery of servers. IPMI can only enabled on one port at a time. IPMI cannot
be enabled on a port that has Large Send Offload enabled. (This property is only supported on the
NC320i, NC7781 and NC7782 adapters.)
Multifunction Gigabit Server Adapters only
• iSCSI properties