Filter
Top Products
Adapter configurations 122
FILES=100
buffers=25
LASTDRIVE=m
fcbs=4,4
device=c:\6150\amsida.sys
device=c:\6150\amsicd.sys /d:cpqcd001
• Example AUTOEXEC.BAT
PROMPT $p$g
@ECHO OFF
C:\dos\mscdex.exe /d:cpqcd001
@CALL C:\nw5c32\STARTNET
Solaris
To customize the driver edit "/kernel/drv/bcme.conf" and update the respective parameters in this file.
The parameters include the following.
• ForceSpeedDuplex. Configures link (or instance) to a certain Speed and Duplex. By default,
AutoNegotiate (0) is set. The setup is based on the following values:
0—AutoNegotiate
1—10 Mbps speed and Half-Duplex mode
2—10 Mbps speed and Full-Duplex mode
3—100 Mbps speed and Half-Duplex mode
4—100 Mbps speed and Full-Duplex mode
5—Force 1000 Mbps Full-Duplex mode (Fiber adapter only)
6—AutoNegotiate only 1000 Mbps Full-Duplex mode
7—AutoNegotiate only 1000 Mbps Half-Duplex mode
8—AutoNegotiate only 100 Mbps Full-Duplex mode
9—AutoNegotiate only 100 Mbps Half-Duplex mode
10—AutoNegotiate only 10 Mbps Full-Duplex mode
11—AutoNegotiate only 10 Mbps Half-Duplex mode
Example: Configure adapters of instance#0 and instance#3 to 100 Mbps Full-Duplex, and 10 Mbps
Half-Duplex.
ForceSpeedDuplex=2,0,0,1,0,0,0,0,0,0,0,0,0,0,0,0;
ForceSpeedDuplex=0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0;
• FlowControl. Configures the flow control parameters of a link. The setup is based on the following
values:
0—Both Tx and Rx flow control are disabled.
1—Tx flow control is enabled. Pause frames will be sent if resource is low, but the device will not
process Rx Pause Frame.
2—Rx flow control is enabled. If the device receives Pause Frame, it will stop sending, but the
device will not send Pause Frame if resource is low.
3—Both Rx and TX flow control are enabled. Pause frames will be sent if resource is low. If the
device receives Pause Frame, it will stop sending.