Filter
Top Products
Diagnostics 162
o
Default Settings
Enabled Tests:
A1. Indirect Register Test
A2. Control Register Test
A3. Interrupt Test
A4. Built In Self Test
A5. PCI Cfg Register Test
B1. Scratch Pad Test
B2. BD SRAM Test
B3. DMA SRAM Test
B4. MBUF SRAM Test
B5. MBUF SRAM via DMA Test
C1. NVRAM Test
C2. CPU Test
C3. DMA Test
C4. MII Test
C5. VPD Test
C6. ASF Test
C7. Expansion ROM Test
D1. Mac Loopback Test
D2. Phy Loopback Test
D4. MII Miscellaneous Test (Copper only)
Disabled Tests:
B6. External SRAM Test
D3. External Loopback Test
• -I <num>
o Use this option to specify the number (iteration) of times the tests are to be run. The default is to
run one time. A number zero indicates loop forever. A control-C or control-break key can be
used to break the loop. Any error detected will also stop testing after reporting the error.
o Example: q57diag.exe -I 5
Runs tests five times
• -ver
o Displays the version of the current test software/eeprom.bin
o If this option is entered, it displays the software version number/silkscreen revision and then exits
the program.
o Example: q57diag.exe -ver
• -bus <num>
o Tests UUT location
o If this option is specified, the program will test all UUTs on the specified bus number. This option
is ignored if -c option is entered.