Filter
Top Products
Firmware upgrade utility 53
Command Line Input Result
nicfwupg_mf.exe -c Displays the current firmware version of all
HP NC-Series Broadcom adapters in the
system
nicfwupg_mf.exe -l Displays the latest version of HP NC-Series
Broadcom adapters in the system as
determined by versions shipped with the
component.
nicfwupg_mf.exe -a Retuns the saved image version of HP NC-
Series Broadcom adapters in the system
nicfwupg_mf.exe -s Suppresses console output
nicfwupg_mf.exe -f Forces downgrades or restores as needed
nicfwupg_mf.exe -p Requests a restore on all adapters
nicfwupg_mf.exe -e [MAC
Address]
Requests a restore on one adapter. Supply
the MAC address for the adapter.
nicfwupg_mf.exe -o [MAC
Address]
Performs an upgrade of boot code for one
adapter. Supply the MAC address for the
adapter.
nicfwupg_mf.exe -x [MAC
Address]
Performs an upgrade of PXE for one
adapter. Supply the MAC address for the
adapter.
nicfwupg_mf.exe -b [MAC
Address]
Performs an upgrade of CLP for one
adapter. Supply the MAC address for the
adapter.
nicfwupg_mf.exe -i [filename] Performs an upgrade and stores the image
file to be used during a restore. Supply the
filename.
Return codes
When the upgrade utility has finished running, the component reports a return code to the operating
system or calling application. These return codes are processed by the %errorlevel% operating system
variable and are used to determine the status of a firmware upgrade procedure.
The following summarizes the return codes for the Smart Component installer and HP Online Firmware
Upgrade Utility commands.
Error level Meaning
0 Upgrade component failed to install
1 Upgrade component installed successfully
3 Upgrade component did not detect any supported network
adapters
4 Firmware upgrade was recommended, but the upgrade
component was instructed to not update the firmware
5 All firmware versions are current and an upgrade is not
recommended
6 At least one network adapter has firmware installed that is
newer than the available firmware.