Filter
Top Products
Adapter configurations 75
• 5–EEPROM read failure
• 6–EEPROM write failure
• 7–EEPROM dump failure
• 8–(Not used)
• 9–No memory
• 10–No adapters found
Examples of IBAUtil command lines
The following are examples of some typical IBAUtil command lines.
• Disables WOL on all HP network adapters:
IBAUTIL -ALL -WOLDISABLE
• Enables WOL on the second HP network adapter found in your system:
IBAUTIL -NIC=2 -WOLENABLE
• Updates the Boot Agent image on all HP network adapters:
IBAUTIL -ALL -UPGRADE
• Enables the Boot ROM on the first HP Network Adapter found in your system:
IBAUTIL -NIC=1 -FE
Boot Agent messages
The following error and information messages may be displayed during initialization. Possible causes and
how to avoid an error condition are provided where applicable.
• Flash device wrong size
This error message can occur when using IBAUtil. The full version of Boot Agent software cannot be
loaded into a flash ROM device smaller than 64 KB. If a 32 KB (or smaller) flash ROM device is
detected in the adapter, the flash update software returns this message. Assuming the device is
socketed, remove the "too small" device and install a blank 64 KB (or larger) flash ROM device.
• Invalid PMM function number
PMM is not installed or is not working correctly. Try updating the BIOS.
• PMM allocation error
PMM could not or did not allocate the requested amount of memory for driver usage.
• Press Ctrl+S to enter the Setup Menu.
Instructs you how to enter the configuration setup menu.
• PXE-E00: This system does not have enough free conventional memory. The Boot Agent cannot
continue.
System does not have enough free memory to run PXE image. The Boot Agent was unable to find
enough free base memory (below 640K) to install the PXE client software. The system cannot boot
via PXE in its current configuration. The error returns control to the BIOS and the system does not
attempt to remote boot. If this error persists, try updating your system's BIOS to the most-recent
version. Contact your system administrator or HP customer support to resolve the problem.
• PXE-E01: PCI Vendor and Device IDs do not match!
Image vendor and device ID do not match those located on the card. Be sure the correct flash image
is installed on the adapter.
• PXE-E04: Error reading PCI configuration space. The Boot Agent cannot continue.