Filter
Top Products
HP OmniBook 7100 Removal and Replacement 2-13
Figure 2-8. Removing the LCD Module
Reassembly Notes
• Make sure the connector on the main display cable seats correctly on the LCD connector.
• Install the LCD shield and three display brackets on the LCD module, then install the complete
assembly onto the posts at the top of the display case. Lower the assembly into the case.
• Route the LCD wires under the main display cable near the right hinge.
Screw cover
Screw, M2.5×8mm
Screw, M2.5×6mm (4)
Screw, M2×3mm (4)
Display bezel
LCD module
Hinge
End cap (2)
Screw, M2.5×3mm
Display cable
Inverter PCA
Display brackets (3)
LCD shield