Filter
Top Products
2-22 Removal and Replacement HP OmniBook 7100
Component Removal Procedures Additional Steps (See figure on page 4-5)
LCD Shield
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
LCD module (page 2-11).
Screw Cover (Display)
Lift off the cover.
Reassembly Notes: Do not install a cover on the
lower display screws.
Table 2-8. Removing Top Case Components
Component Removal Procedures Additional Steps (See figure on page 4-6)
Hinge Cover, Left
Open the display fully, then press on the front of the
hinge cover until it releases from the top case.
Reassembly Notes: Install the flat wall toward the
front.
Hinge Cover, Right
Plug-in module (page 2-3).
Keyboard (page 2-8).
Heatsink (page 2-9).
Keyboard
See page 2-8.
Speaker
Plug-in module (page 2-3).
Hard drive (page 2-5).
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
Top case (page 2-14).
1. On the underside of the top case, remove the
screws from the speaker cover and remove the
cover.
2. Release the four tabs protruding through the metal
plate—you do not need to disconnect the touch-pad
assembly.
3. Remove the screws from the edges of the metal
plate. Then remove the two screws from the PCA
beneath.
4. Lift up the front of the metal plate and two PCAs,
then unplug the speaker cable.
Reassembly Notes: During assembly, make sure the
speaker wires do not affect the touch-pad buttons, and
the speaker/touch-pad cable routes through the cutout
in the speaker cover.
Touch-pad Cable
Plug-in module (page 2-3).
Hard drive (page 2-5).
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
Top case (page 2-14).
1. On the underside of the top case, release the four
plastic tabs protruding through the metal plate.
2. Release the flex cable from the top case and from
the touch-pad PCA.
Touch-pad PCA
Plug-in module (page 2-3).
Hard drive (page 2-5).
Keyboard (page 2-8).
Heatsink (page 2-9).
Display (page 2-11).
Top case (page 2-14).
1. On the underside of the top case, release the four
plastic tabs protruding through the metal plate.
2. Release the flex cable from the top case.
3. Release the two snaps along one side of the plastic
housing, then lift off the plastic cover and pop out
the touch-pad PCA.