Filter
Top Products
To set up the HP All-in-One on a wired
network, you need to do the following:
See this section:
First, collect all of the required materials. “What you need for a wired network”
on page 6
Next, connect to a wired network. “Connect the HP All-in-One to the network”
on page 7
Finally, install the software. “Install the software for a network connection”
on page 14
What you need for a wired network
Before you connect the HP All-in-One to a network, make sure you have all of the required
materials.
❑
A functional Ethernet network that includes a router, switch, or hub with an Ethernet
port.
❑
CAT-5 Ethernet cable.
Although standard Ethernet cables look similar to standard telephone cables, they
are not interchangeable. There is a different number of wires in each one, and each
has a different connector. An Ethernet cable connector (also called an RJ-45
connector) is wider and thicker and always has 8 contacts on the end. A phone
connector has between 2 and 6 contacts.
❑
A desktop computer or laptop with an Ethernet connection.
NOTE: The HP All-in-One supports both 10 Mbps and 100 Mbps Ethernet
networks. If you are purchasing, or have purchased, a network interface card
(NIC), make sure it can operate at either speed.
Chapter 2
6 Network setup
Network setup