Filter
Top Products
The print carriage moves to the center of the product.
Open the cartridge door
c. Remove a cartridge by pressing on the tab and removing the cartridge from the slot.
d. Reinsert the cartridge by sliding it forward into the slot until it clicks.
Reinsert a cartridge in the correct slot
e. Repeat steps c and d for each of the remaining cartridges.
f. Run a finger along the top of the ink cartridges to locate any cartridges that are not snapped completely
down.
g. If any cartridge was sticking up and does not snap back down into place, the cartridge tab might need to be
readjusted.
Solution two: Readjust the cartridge tab
▲ Remove the ink cartridge from the carriage.
Readjust the cartridge tab
a. Gently bend the tab away from the ink cartridge. Be careful not to bend the tab out more than about 1.27
cm (0.5 inches).
Bending the tab out
Chapter 1
44 Online Topics
Online Topics