Filter
Top Products
Paper specifications 119
Labels
CAUTION To avoid damaging the product, use only labels recommended for use in laser printers.
If you have problems printing labels, use Tray 1 and open the rear output slot.
Do not print on the same sheet of labels more than once—peeling and adhesive
contamination might result.
Label construction
When selecting labels, consider the quality of each component:
● Adhesives: The adhesive material should be stable at 230° C (446° F), the
product’s maximum temperature.
● Arrangement: Only use labels with no exposed backing between them. Labels can
peel off sheets with spaces between the labels, causing serious jams.
● Curl: Prior to printing, labels must lie flat with no more than 13 mm (0.5 inch) of curl
in any direction.
● Condition: Do not use labels with wrinkles, bubbles, or other indications of
separation.
To print sheets of labels, see “Using labels” on page 27.
Transparencies
Transparencies must be able to withstand 230° C (446° F), which is the product’s
maximum temperature. Print transparencies to the top output bin by closing the rear
output slot.
Transparencies can be printed from Tray 1 or Trays 2, 3, or 4. To print transparencies,
see “Using transparencies” on page 27. If you experience difficulties, use Tray 1. Make
sure you remove each transparency from the output tray when it is printed to prevent
sticking.
CAUTION To avoid damaging the product, use only transparencies recommended for use in laser
printers.