Filter
Top Products
A print job was not sent to the product that you wanted.
Cause Solution
The print queue might be stopped. Open the print queue, and then click Start Jobs.
The wrong product name or IP address is being used. Another
product with the same or similar name, IP address, or "Rendezvous"
or "Bonjour" host name might have received your print job.
Check the product name, IP address, or "Rendezvous" or "Bonjour"
host name by printing a configuration page. Verify that the name, IP
address, or "Rendezvous" or "Bonjour" host name on the
configuration page matches the product name, IP address, or
"Rendezvous" or "Bonjour" host name in the Printer Setup Utility.
An encapsulated PostScript (EPS) file does not print with the correct fonts.
Cause Solution
This problem occurs with some programs.
●
Try downloading the fonts that are contained in the EPS file to
the product before printing.
●
Send the file in ASCII format instead of binary encoding.
You are unable to print from a third-party USB card.
Cause Solution
This error occurs when the software for USB printers is not
installed.
When adding a third-party USB card, you might need the Apple USB
Adapter Card Support software. The most current version of this
software is available from the Apple Web site.
When connected with a USB cable, the product does not appear in the Macintosh Printer Setup Utility after the driver is selected.
Cause Solution
This problem is caused by either a software or a hardware
component.
Software troubleshooting
●
Check that your Macintosh supports USB.
●
Verify that your Macintosh operating system is Mac OS X v10.3
or Mac OS X v10.4.
●
Ensure that your Macintosh has the appropriate USB software
from Apple.
Hardware troubleshooting
●
Check that the product is turned on.
●
Verify that the USB cable is connected correctly.
●
Check that you are using the appropriate high-speed USB cable.
●
Ensure that you do not have too many USB devices drawing
power from the chain. Disconnect all of the devices from the
chain, and connect the cable directly to the USB port on the host
computer.
●
Check to see if more than two nonpowered USB hubs are
connected in a row on the chain. Disconnect all of the devices
Table 11-1 Problems with Mac OS X v10.3 and Mac OS X v10.4 (continued)
ENWW Solve software problems 107