Filter
Top Products
Serial/Telnet User Interface
90 Network Storage Router N1200 User Guide
Serial UI Access
To open a serial session, a terminal emulator utility is required.
From most Windows 9x, Windows NT, and Windows 2000 systems, a
HyperTerminal session can be started using the following steps:
1. From the Windows Start Menu, open HyperTerminal.
2. Name the new terminal session.
3. Indicate the appropriate COM port.
4. Configure the serial port settings, as listed in Table 7.
Table 7: Serial Port Configuration
Note: HP recommends setting the baud rate to 115200.
5. After completing the serial port configuration, select OK to start a serial
session.
6. After the serial session has started, press Enter several times to initiate router
communication and display the Configuration Menu.
BAUD Rate
Autobaud, 9600, 19200, 38400, 57600, 115200
Data Bits
8
Stop Bit
1
Parity
None
Flow Control
XON/XOFF