Filter
Top Products
3. Route the processor turbo fan power cables through the processor heatsink posts so that the
cables will not be pinched between the heatsink posts and the processor airflow guide
(Figure 6-32).
CAUTION: Turbo fan power cables can be damaged if pinched between the heatsink posts
and the processor airflow guide. Ensure that the cables are below the top surface of the
heatsink posts before installing the processor airflow guide.
Figure 6-32 Routing Power Cables Through Heatsink Posts
4. Replace the main portion of the airflow guide:
a. Hold the opening on top of the processor airflow guide.
b. At the same time, grasp the back end of the airflow guide and insert the airflow guide
into the server.
c. Connect the power module cable.
d. Place the power and IDE cables in the cable clips.
e. Insert the two airflow guide retaining tabs into the two slots on the front half of the
airflow guide.
5. Replace the memory airflow guide. (See “Removing and Replacing the Memory Airflow
Guide” (page 144).)
6. Replace the top cover.
7. Reconnect the power and external cables.
Removing and Replacing System Memory
The server has 12 memory sockets for installing DDR SDRAM memory modules. The server
supports the following combinations
• For rp3410 - from 512 MB up to 6 GB
• For rp3440 - from 1 GB up to 32 GB
System memory DIMMs are located on the system board.
Supported DIMM Sizes
Supported DIMM sizes are as follows:
Removing and Replacing System Memory 149