Filter
Top Products
Figure 6-59 Replacing the PCI Backplane
3. Replace any PCI and graphics cards. (See “Replacing a PCI or Graphics Card” (page 170).)
4. Replace the PCI card cage. (See “Replacing the PCI Card Cage” (page 168).)
5. Verify the backplane replacement and operation by using the system utilities. (For additional
information, see Appendix B (page 199) or the HP Integrity and HP 9000 iLO MP Operations
Guide.)
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.
Removing and Replacing a Removable Media Drive
The removable media drive is located behind the front bezel.
WARNING! Ensure that the server is powered off and all the power sources have been
disconnected from the server before removing or replacing a removable media drive.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to
follow ESD safety precautions can result in damage to the server. Failure to properly complete
the steps in this procedure will result in erratic server behavior or system failure. For assistance
with this procedure contact your local HP Authorized Service Provider.
Removing a Removable Media Drive
To remove a removable media drive, follow these steps:
1. Power off the server and disconnect the power and external cables.
2. Remove the top cover. (See “Removing and Replacing Server Covers and Bezel” (page 126).)
3. Disconnect the IDE cable from the back of the drive.
4. Grasp the front of the drive and squeeze in on the locking tabs to release the drive.
172 Removing and Replacing Components