Filter
Top Products
Figure 1-16 iLO MP Card LAN LEDs
Table 1-15 lists the iLO MP card LAN LEDs.
Table 1-15 iLO MP Card LAN LEDs
DescriptionColorLED
iLO MP is running self-test or error is detectedYellowSelf-test
10BT link established, flashing green 10BT link activity, off no linkGreen10BT
100BT link established, flashing green 100BT link activity, off no linkGreen100BT
Standby power on, off standby power offGreenStandby power
Table 1-16 lists the iLO MP card LAN connector pinouts.
Table 1-16 iLO MP Card LAN Connector Pinouts
Signal DescriptionPin Number
TXP1
TXN2
RXP3
Not used4
Not used5
RXN6
Not used7
Not used8
Powering the Server On and Off
This section provides information on how to power the server on and off.
Power States
The server has three power states:
• Standby power
• Full power
• Off
Plug the power cord into the appropriate receptacle on the rear of the server to achieve the
standby power state; the front panel Power button is not turned on. Full power occurs when the
power cord is plugged into the appropriate receptacle, and either the power is activated through
the iLO MP PC command, or the Power button is activated. In the off state, the power cords are
not plugged in.
Table 1-17 lists the server power states.
38 Overview