Filter
Top Products
18-16
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 18 Configuring SPAN and RSPAN
Configuring RSPAN
Removing Ports from an RSPAN Session
Beginning in privileged EXEC mode, follow these steps to remove a port as an RSPAN source for a
session:
This example shows how to remove port 17 as an RSPAN source for RSPAN session 1:
Switch(config)# no monitor session 1 source interface gigabitethernet0/17
Switch(config)# end
This example shows how to disable received traffic monitoring on port 17, which was configured for
bidirectional monitoring:
Switch(config)# no monitor session 1 source interface gigabitethernet0/17 rx
The monitoring of traffic received on port 1 is disabled, but traffic sent from this port continues to be
monitored.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
no monitor session session_number source
interface interface-id [, | -] [both | rx | tx]
Specify the characteristics of the RSPAN source port (monitored
port) to remove.
For session_number, specify the session number identified with
this RSPAN session.
For interface-id, specify the source port to no longer monitor. Valid
interfaces include physical interfaces and port-channel logical
interfaces (port-channel port-channel-number).
(Optional) Use [, | -] to specify a series or range of interfaces if they
were configured. Enter a space before and after the comma; enter
a space before and after the hyphen.
(Optional) Specify the direction of traffic (both, rx, or tx) to no
longer monitor. If you do not specify a traffic direction, both
transmit and receive are disabled.
Step 3
end Return to privileged EXEC mode.
Step 4
show monitor [session session_number] Verify your entries.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.