Filter
Top Products
9. Make sure the clips on either end of the socket snap into place to hold the SIMM.
If necessary, use your thumbs to move the clips upright into the grooves to lock the
SIMM in place.
10. Verify that the SIMM is correctly installed in the socket by looking at its position
from the sides of the controller card.
11. If you are also installing a hard drive, go to step 7 on page 159.
12. Place the controller card back into the printer.
13. At the back of the printer, tighten the thumb screws that fasten the controller card.
14. Connect cables to the controller board.
15. Connect the power cord to the back of the printer.
Chapter 7. Installing Printer Options 157