Filter
Top Products
261 NewSourceAddress
262 SourceAddressTimeout
263 BoardRemoval
264 BoardInsertion
265 ActivePortInRedundantCircuitFailed
266 RedundantPortActivated
267 RedundantPortTesfFailed
268 DeviceTrafficThresholdExceeded
269 DeviceErrorThresholdExceeded
270 DeviceCollisionThresholdExceeded
271 BoardTrafficThresholdExceeded
272 BoardErrorThresholdExceeded
273 BoardCollisionThresholdExceeded
273 BoardCollisionThresholdExceeded
274 PortTrafficThresholdExceeded
275 PortErrorThresholdExceeded
276 PortCollisionThresholdExceeded
277 PortTypeChanged
278 LockSTATUSChanged
279 PortSecurityViolation
280 PortViolationReset
281 EnvTempWarm
282 EnvTempHot
283 EnvVoltageLow
Creating a New SNMP Trap Event
To create a new SNMP trap event using an SNMP Management Information Base
(MIB) file, change the following files:
v tecad_snmp.baroc
v tecad_snmp.cds
v tecad_snmp.oid
This section describes traps from the LANAlert FSA for NetWare 3.x. Traps from
other agents are similar.
BAROC File Changes
From this partial MIB file, create a lanalertFSA-NW3-s1 event in the
tecad_snmp.baroc file.
-- LANAlert Forwarding Gateway MIB (partial)
-- NCI 27 June 1995
LANAlert-AFG-Trap DEFINITIONS ::=
Chapter 7. SNMP Adapter 89