Filter
Top Products
Twinax Setup Menu
Use the Twinax Setup menu to configure the Twinax attachment. The following table
describes the settings you can change from the Twinax Setup Menu. An asterisk (*)
next to a value in the table indicates the factory default. The Twinax Setup Menu
appears only if you have the twinax attachment installed.
Notes:
1. To select a new value, press the Continue/Enter key when the value is displayed
in the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that it is now active.
Important! If you change SCS ADDR or IPDS ADDR, you must power off the
printer, wait ten seconds, and then power on the printer for the new value to take
effect.
2. For more information about configuring the twinax attachment, see
IBM Network
Printers: Twinax/Coax Configuration Guide
.
3. If you are unfamiliar with using the operator panel to work with menus, please read
“Using the Operator Panel Keys” on page 10 and “Navigating Menus” on page 12
before continuing.
TWINAX SETUP
MENU ITEM
VALUE Description
SCS ADDR OFF*
n
The twinax hardware address of the SCS port. n can be from 0 to
6.
Notes:
1. SCS ADDR and IPDS ADDR cannot be set to the same
value.
2. If you change SCS ADDR or IPDS ADDR, you must power
off the printer, wait ten seconds, and then power on the
printer for the new value to take effect.
3. When the optional IPDS SIMM is installed, each IBM
Network Printer can act as two separate printers on the same
twinax port. (The printer cannot be attached to two different
twinax systems using the same twinax card.) One “printer”
prints SCS data to one address (SCS ADDR), and the other
prints IPDS to another address (IPDS ADDR).
100 Network Printer 17: User’s Guide