Filter
Top Products
Removing the 500-Sheet Paper Tray Support Units
Use the following procedure to remove the 500-sheet paper tray support unit:
1. Switch the printer power off.
2. Unplug the printer from the wall outlet.
3. Remove the power cord from the back of the printer.
4. Open the power-cord connector cover that is located on the back panel of the
lower support unit. Release the latch and open and remove the cover.
Note: If two support units are installed, remove both covers.
5. Unplug the power-cord connector from the printer jack by holding the power-cord
connector (not the wire harness) and pulling straight down.
Note: If two support units are installed, unplug both power-cord connectors.
156 Network Printer 17: User’s Guide