Filter
Top Products
Hardware Installation 7
MCMaster User’s Guide - Rev. B06 Kingston Technology Company
Installing the MCMaster
1. Make sure that the system power switch is OFF.
2. Unlock and remove the system cover. Your PS/2 Quick
Reference provides detailed instructions for removing or
reinstalling the cover.
3. Choose a vacant expansion slot to plug MCMaster card into.
MCMaster will work in a 16 or 32-bit slot. If you're installing it
in a 32-bit system, such as a Model 70 or 80, you'll want to
install it in a 32-bit slot to take full advantage of the 80486
processor's 32-bit bus width.
4. Loosen the screw that holds the expansion slot cover, and slide
out the expansion slot cover. Save it.
5. Install MCMaster board in its slot by carefully sliding it in until
the board snaps into place. Be careful that the forked bottom of
the backplate goes outside the lip of the chassis. Finger-tighten
the screw.
6. Replace the system cover, and tighten the screws.