Filter
Top Products
Setting up the printer
2-20 October 1997
two connectors.
3. Connect the LocalTalk cable to the two connectors.
4. Connect the power cord. See "Connecting the power cord" on
page 2-22.
5. Turn the printer
On
(press the power switch on the side of the printer
to |).
IMPORTANT: The printer can initialize itself only if the computer is
On.
Connecting a SCSI cable
The SCSI connection is active only when the printer is operating in
raster mode. The default SCSI ID for the printer is 5.
To connect a SCSI cable:
1. Make sure that both the printer and the computer are turned
Off
.
2. The default SCSI ID is 5. To change the SCSI ID see "About
specifying port information" on page 3-6.
LocalTalk port
(PostScript printing only)