Filter
Top Products
Operating the printer
3-6 October 1997
Working in Setup mode
To enter Setup mode: Press Setup/Select while the printer is idle.
To scroll through the settings: Press Print to scroll up, Cancel to scroll
down. You scroll through the settings continuously.
To select an option: When you find the setting whose options you wish
to view, press Setup/Select. An asterisk (*) next to an option means it is
selected.
To exit Setup mode: Select SETUP:EXIT. Most changes you make are
effective as soon as you exit Setup mode. The exceptions are when you
return the settings to the factory defaults, and when you change the
printer's operating mode. In these cases, the printer restarts itself when
you exit Setup mode. Changes are effective immediately afterward.
To restore the printer settings to their factory settings: Press Setup/
Select when SETUP:DEFAULTS appears. Select FACTORY:RESET to
restore all the printer settings to their factory settings.
IMPORTANT: If the Network Interface Card is installed, restoring the
settings to their factory values may cause network
printing problems.
About specifying port information
The options you select must match your host computer settings.
There are different submenus associated with the PORTS menu. Which
ones are available depends on whether the printer is running in Raster
or PostScript mode, and on whether the Network Interface Card is
installed.